The JLR balance shaft timing tool set is used to rotate and adjust the balance shaft. Designed for DOHC 2.2 diesel engines. Application: Ford, Land ... more info

The Benz inner chain check valve installer is specially designed to install the inner chain check valve. Application Benz M276 engine. MM number: ... more info

The VAG crankshaft rotator is specially designed to turn the crankshaft over and into position for alignment purposes. Application: VAG 2.7 / 3.0 TDi ... more info

The VAG clutch holding tool is used to assemble clutches on VAG 6 speed Direct Shift Gearboxes (DSG) model. Applicable: VAG 02E – 6 speed DSG ... more info

The oil filter locking pliers 280 mm are adjustable and fixed to work at any angle. The jaws are made of chrome vanadium steel. Jaws opening: 45 ... more info

• Specialty tool for the timing belt replacement on 1.4, 1.6, 1.8, and 2.0 16V engine fits in Renault, Nissan, and Vauxhall and Opel series ... more info

Specially designed to remove the diesel injector by 17T hydraulic cylinder kit. The set enables the controlled extraction of very tight fitting or ... more info

The Land Rover V8 ball joint is specially designed to remove and install the ball joint on the vehicle without removing any parts. Application: Land ... more info

The JLR timing tool set is used with JTC-4244 to correct engine timing position on JLR 5.0 V8, and 3.0 V6 vehicles. Specially designed to set high ... more info

• Special design to stop the pulley and remove the center bolts and the V-belt pulley   at the generator. • Use with 17mm wrench.) ... more info