The tool is specially designed for holding the sliding rod and pulling out the injector with the air hammer. Saves time and work. Used with JTC-4530 ... more info

The Kia flywheel locking tool is designed to hold the flywheel when removing or installing the crankshaft damper pulley. Application: i30 (FDe), i30 ... more info

The 2 jaws windshield wiper puller is specially designed self-gripping jaws used to disconnect the battery terminals. Slim 2 jaws puller for confined ... more info

The wheel hub grinder for European cars is used for cleaning the wheel centering device as well as the attachment area between the wheel and hub. ... more info

The tool is specially designed to remove or install center-lock wheel nuts on Porsche 997, 991, GT2 and GT3 models. Drive 3/4″ inch, tightening ... more info

? Ideal to remove and install the transmission clutch piston snap ring. ? Applicable: most models of European, Japanese and American cars and ... more info

The extra large inner tie rod tool can easily replace the inner tie rod ends without removing the rack and pinion. New larger size not only provide ... more info

The JLR crankshaft oil seal remover and installer specially designed to remove and install the crankshaft rear oil seal on JLR vehicles. Application: ... more info

The tool is specially designed for installing the crankshaft trigger wheel. Overall diameter: 12.5 cm (4.9″). Application: Discovery 3, ... more info

The Ford Transit lower control arm bush tool is specially designed to remove and replace the large rear bush on the lower control arms of Ford ... more info