The BMW differential bush extractor is specially designed to assemble and disassemble the front bush (2 pieces) and rear bush (1 piece) of the ... more info

The set of heads are used for removal and installation of secret bolts and nuts of Tesla vehicle model S, X. Contents: #76, #77, #78, #79, #80, #81, ... more info

• Used for straight push connectors. Applicable tube sizes: Ø 4, 6, 8, 10, 12mm. • Rotating head: H14mm. • Clamping range: ... more info

Used to position leakage on tube cooler, pipe, exhaust system, intake pipe…and so on. Adjustable smoke pressure up to 0.1Mpa (1 bar) / 14.5 ... more info

The BMW front crankshaft oil seal is specially designed to protect and install the front crankshaft oil seal to the correct position. Application: ... more info

The VAG high pressure pump pulley is specially designed to remove high pressure pump on VAG 1.4L, 1.6L, 2.0L Common Rail TDI engines. Application VW ... more info

•  Special designed to remove the half axle of CV joint on car. •  Center aperture Ø 34mm?Inner diameter width: 115mm. ... more info

The BMW large differential gear socket is the enlarged type of JTC-4463 #4. Designed for fixing the center shaft gear of the differential. ... more info

The VAG rear crankshaft seal installer is used when assembling PTFE crankshaft seals on the flywheel end. Application: VW, Audi 1.8L Turbo, 2.0L ... more info

The adjustable seal puller has a head design that adjusts to 7 positions. Two hook sizes which easily remove most oil and grease seals. The ... more info