The curved multi-direction hose clamp pliers are long reach pliers that are able to access limited spaces easily. Special crossing grooves which ... more info

The set is specially designed to extract the inner bearing rings on the wheel hub while removing the wheel bearing. Application: Audi, BMW, Benz, ... more info

Specially designed to remove HUB rear axle. Operating with 10T hydraulic ram, fast and labor-saving. (Coupler: JTC-CP210), fast and labor-saving. ... more info

Specially designed to remove HUB rear axle. Designed to be operated by 12 ton hydraulic ram. P.C.D. range from 100 – 130 mm. Application: 5 ... more info

The set is used on damaged screws and nuts. Special spiral design for removing the damaged screws easily. Can be used with an air impact wrench. ... more info

The JLR crankshaft rear oil seal installer is specially designed to install the crankshaft rear oil seal on JLR vehicles. Application: Land Rover ... more info

The Subaru camshaft pulley holder is used to hold the camshaft pulley. Weight 4 lbs  

The VAG transmission gear remover is specially designed to remove the sixth speed gear wheel including synchro-hub. Application: 6-speed manual ... more info

The VAG diesel injector tube remover TDI is specially designed to safely remove and install the fuel return line from injectors. Application: VAG ... more info

The Ford Duratec crankshaft pulley is specially designed to hold the crankshaft pulley while the pulley retaining bolt is loosened / tightened. ... more info