Special design for using on brake caliper. Specification: 0-66 mm x 0.01 / 0-2.4″ x 0.0005 Display number size: 11 mm. Metric and inch system ... more info

The tool is specially designed to measure the transmission depth. Spec: 0 – 200 mm x 0.01 / 0 – 8″ x 0.0005. Display number size: 8 ... more info

Tool set includes camshaft setting tool, tensioning tool for auxiliary drive belt and crankshaft TDC timing pin. Application: Volvo 1.6, 1.8, 1.9, ... more info

The timing tool is specially designed to rotate and adjust the balance shaft, align the oil pump and lock the flywheel. Designed for the DOHC 2.2 ... more info

The Benz crankshaft pulley holding tool is specially designed for turning, removing, and installing the crankshaft center bolt. For horizontal shaft ... more info

The slotted socket set is specially designed for flare nuts on high pressure fuel lines and EGT sensors. Contents: 3/8″ Dr. 13, 14, 17 mm 6 PT ... more info

The Ford Duratec crankshaft pulley is specially designed to hold the crankshaft pulley while the pulley retaining bolt is loosened / tightened. ... more info

The VAG diesel injector tube remover TDI is specially designed to safely remove and install the fuel return line from injectors. Application: VAG ... more info

The VAG transmission gear remover is specially designed to remove the sixth speed gear wheel including synchro-hub. Application: 6-speed manual ... more info

The Subaru camshaft pulley holder is used to hold the camshaft pulley. Weight 4 lbs