The tool is for the measurement while replacing and setting up the clutch. Specification: 500mm length Applicable: VW, AUDI 7-speed DSG Transmission ... more info

Applicable with JTC-4252 and JTC-4539 Weight 1.15 lbs

The VAG vibration damper assembly tool is specially designed to fix the timing chain drive sprockets while installing and removing the vibration ... more info

REAR AXLE TRAILING ARM BUSH INSTALLER/REMOVER FOR FORD/VOLVO VEHICLES  The rear axle trailing arm bush tool is designed for installation and ... more info

The Volvo fuel injector remover is specially designed for correct removal of the injection nozzles with the slide hammer. Application: 1.0L, 2.0L ... more info

• Special design to stop the pulley and remove the center bolts and the V-belt pulley   at the generator. • Use with 17mm wrench.) ... more info

The JLR timing tool set is used with JTC-4244 to correct engine timing position on JLR 5.0 V8, and 3.0 V6 vehicles. Specially designed to set high ... more info

The Land Rover V8 ball joint is specially designed to remove and install the ball joint on the vehicle without removing any parts. Application: Land ... more info

Specially designed to remove the diesel injector by 17T hydraulic cylinder kit. The set enables the controlled extraction of very tight fitting or ... more info

• Specialty tool for the timing belt replacement on 1.4, 1.6, 1.8, and 2.0 16V engine fits in Renault, Nissan, and Vauxhall and Opel series ... more info