To replace steering mechanism oil seal by loosen and tighten the nut.   It might damage the related parts while replacing oil seal ... more info

   Special designed for replacing the brake disc and brake caliper on Knorr-Bremse brake system. Also for installing/removing the inner ... more info

   Special designed to loose and tight the rear wheel nut. Both sides of pin are adjustable. Different sizes of pins are suit ... more info

   Designed for removing and replacing truck position sensor.  Use with 1/2” drive wrench. Overall length: 60mm Applicable: ... more info

   Designed for removing truck ball joint without damage the ball joint and related parts. On car maintenance Use with 26mm wrench. ... more info

Designed to tremove the truck wheel hub with variable sizes. Contents: Thread adapters: M18, M20, M22, M24, M30 and 2 size of pressure plates. ... more info

   Special Injector puller solution for new generation trucks Applicable: trucks with injector-Pump systems or with traditional truck ... more info

Designed for all Japanese truck dismantling front and rear axles. Use with 46mm wrench. Size: φ 259x32mm. Applicable: Japan truck HINO, ... more info

Special designed to remove the install the valve of Japanese trucks. Applicable: FUSO 3.5 tons, FUSO over 15 tons, Hino 750, ISUZU 180, 200.

   Special 5 teeth designed to adjust the brake caliper. Overall length: 46mm Use with 36mm wrench. Material:SCM440. Applicable: most of ... more info