The VAG brake caliper socket 10 PT is used for removing and installing the brake caliper. Size: 3/8″ Dr. 11.5 mm x 10 PT, 31 mm (Length). ... more info

The wheel screw lock socket 17 mm is specially designed for removing and installing the 7 PT anti-theft wheel nut. Material: CR-MO. Size: 1/2″ ... more info

The combination AIC system tester is used for testing the cooling system; includes pressure test, temperature sensor, water pump, thermostat and ... more info

The Benz M272 camshaft holding tool is specifically designed to hold the camshaft and prevents it from rotating. Application: Benz M272 and M273 ... more info

The enlarged internal bearing remover accessories must be used with JTC-4672. Contents: Jaw set sizes: 34 – 38 mm; 39 – 43 mm; 44 – ... more info

Oil seal tool for replacing the crank seal or removing the front engine cover. Specially designed for Duratorq engines. Application: Ford Transit, ... more info

The Ford crankshaft pulley holding tool is used for preventing the crankshaft from rotating when releasing or tightening the crankshaft pulley ... more info

The Renault combination timing tool set is specially designed for setting and locking the timing position on Renault petrol and diesel vehicles. ... more info

The BMW N55 exhaust camshaft holder is used for locating upper and lower bearing strip when installing the exhaust camshaft. Application: BMW N55, ... more info

The rear trailing arm bush installer and remover is specially designed for easy removal and installation of the rear arm bush. This tool can insert ... more info