CV Joint Boot Banding With Cutter Tool (4640)

• Condition: New
• Tool is easily removed, by sliding sideways after winding has been completed
• This tool is used to install and tighten the band and strap style clamp on CV joint boots and power steering rack and pinion steering gear boots
• Applications include but not limited to automotive, industrial, agricultural, and rv.
• Bands are installed into the tool and tighten by turning the tool handle. Use a socket or wrench on tool handle to torque the band to specs.
• Built in cutter cuts the banding by flipping tool lever forward once boot clamp has been tightened to spec.

Instructions:

1. Place band around boot and through nose of tool and through slot  in winding body.
2. Using a 1/2" socket wrench or by hand wind the band until sufficient tension is applied.
3. Rotate handle over the boot to lock the band.
4. Slide tool free-end down with a hammer.

• Operated by hand or 1/2" wrench.            
• This tool is easily removed by sliding sideways after winding has been completed.